Configuration of the Operating Mode
TE mode is set if the ISDN connection is connected to an NTBA or the SwyxWare is configured as a subsystem. NT mode is set if the ISDN connection is used for an external subsystem or directly connected ISDN telephones are to be used.Each BRI bus connection is a jumper block with five assigned jumpers. If all five jumpers are inserted to the left, the connection is configured as NT. If all five jumpers are on the right-hand side of the block, the connection is configured as TE. So on one board some connections can operate in NT mode and other in TE mode at the same time.
All five jumpers of one block must have the same position, e.g. all facing to the right, or all facing to the left.
After the installation of the driver software, the same operating type must be set in the configuration dialog. It is therefore not sufficient to configure the operating mode on the hardware only or in the software only.
Last modified date: 01/24/2024