12.3.1.1 Prepare hardware
All DECT base stations must be connected to your LAN and switched on.The DECT base station you want to provide as master base station must have Ascom AG firmware 11.4.4 or higher.
If you are already operating a conventionally configured DECT system in your network which should remain, you must also update its base stations to firmware 11.4.4 or higher.
When deploying the new system, the already configured base stations remain assigned to the existing DECT system and are not automatically provisioned for the new system.
When deploying the new system, the already configured base stations remain assigned to the existing DECT system and are not automatically provisioned for the new system.
If your DECT base stations are still operating with an older firmware version, you must update them manually.
On the master base station, you must also manually update the bootloader.
See the section "Updating SwyxDECT 800" in help.enreach.com/docs/manuals/english/SwyxDECT800.pdf
On the master base station, you must also manually update the bootloader.
See the section "Updating SwyxDECT 800" in help.enreach.com/docs/manuals/english/SwyxDECT800.pdf
A factory reset must be performed on the base station that you want to configure as master, see Perform factory reset.The Ascom AG Firmware 11.4.4 or higher for DECT base stations and DECT handsets must be available in your SwyxWare system, released for the corresponding end devices and distributed, see Distributing software to clients or devices. If the handset was already in use, you must perform a factory reset via the administration menu for successful provisioning. See To unlock the administration menu.
Dial on the handset:
Menu | Calls | Admin Menu | Factory reset
Dial on the handset:
Menu | Calls | Admin Menu | Factory reset
Last modified date: 01/19/2024